Follow-up campaign conditions and templates
Types of follow up campaigns, follow-up conditions, retarget failed, retarget sentA follow-up campaign targets customers from an earlier (parent) campaign. The Conditions you pick decide who gets it, and the template you choose decides what they see. Two common cases are below. For the full setup, see Send a follow-up campaign.
The two common cases
Section titled “The two common cases”| Reach customers who missed your message | Retarget customers who got your message | |
|---|---|---|
| Example name | “Failed Follow Up” | A name that says what the follow-up is for |
| Condition | Failed | Sent |
| Logic | AND, so only the parent campaign’s failed customers are included | AND or OR, depending on your conditions |
| Template | Present template: they never saw it, so send the same message | New template: they have already seen the first message |
| Cost | Charged (these customers are not in an open conversation) | Free within 24 hours of the parent campaign |
Reach customers who missed your message
Section titled “Reach customers who missed your message”Use the Failed condition for customers the parent campaign didn’t reach. Since they haven’t seen the message, reuse the parent campaign’s template with Present template to keep it consistent. Check the preview on the right, then click Review and launch or Launch immediately.
Retarget customers who got your message
Section titled “Retarget customers who got your message”Use the Sent condition for customers who received the parent campaign. Choose New template, since they have already seen the first message. You are taken to the campaign page to select the template and fill its fields. Test the campaign, then launch it now or schedule it.
Create the new template and get it approved before you start, so the follow-up isn’t held up.
- Give each follow-up a clear name, such as “Failed Follow Up”, so you can find it later.
- Use AND for a narrow audience (every condition must match) and OR for a wider one (any condition can match).
- Always preview and test before you launch.
Related
Section titled “Related”Was this page helpful?
Thanks, this helps us improve this page.
Still stuck? Email support@businessonbot.com